We know that the enamelled reactor has excellent properties such as corrosion resistance, and in order to make it to play its advantages,it is necessary to operate it correctly to prevent equipment damage due to improper operation,Mixing is an important step. Let's take a look at how to mix.
1, In the process of dropping and heat preservation, the temperature and pressure of enamelled reactor shall be checked frequently, and the dropping materials and materials in the reactor shall be comprehensively observed and recorded. When the temperature and pressure of the reactor and the material are abnormal, corresponding measures shall be taken in time to adhere to the normal reaction form to prevent equipment and personal accidents.
2. When taking materials out from the reactor, the mixing shall be stopped for more than 2 minutes, and it can be stopped only after it is confirmed that there are no other potential safety hazards. It is not suitable to use a scattered hard metal vessel to pull out from the reactor for sampling, so as to avoid damaging the glass surface.
3. After putting the material into the reactor, the relevant valve should be adjusted to a suitable open-close position, and the agitation can be opened, if the reactor is found to have distinct noise and vibration and other abnormal ,need emergency stop disposal. If the reactor is mixed with solid powder, etc. , need to be fully dissolved before start stirring.
4. The circulating water of the relevant condenser should be opened before the electric heating of the reactor. Should first turn over drain bypass valve, slowly turn over the steam valve, drain water, pipe bypass valve, a trap to stop the drain task, so that the jacket preheating.
The above is the correct operation of the agitation of the enamelled reactor, and for the equipment, not only this step, but all the operations should be carried out according to the regulations, so as to avoid the occurrence of accidents, make the equipment last longer.